I suspect this problem could be due to the poor Wi-Fi connection. However, I don’t rule out the possibility of some other villains like faulty Bluetooth connection. Whatever could be spoiling your party, let’s nab the culprit and take it to the task without any further ado!
How to Fix Setup Failed 301003 Error on HomePod
Before going ahead, make sure you have fully covered the basic requirements:
Be sure your iPhone or iPad is running iOS 11.2.5 or lateriCloud Keychain must be enabled on your iOS device to let the smart speaker access some of your information. Settings → Apple ID banner → iCloud → Keychain → iCloud KeychainMake sure you have already set up two-factor authentication for your Apple ID
Solution #1: Check Your Wi-Fi Connection
HomePod requires your local Wi-Fi connection to work. Make sure it’s working properly. Open Settings app on your iOS device → Wi-Fi → turn off Wi-Fi. Now, wait for some time and check out if it is working effectively or not. If Internet hasn’t yet returned to normalcy, remove the Wi-Fi network, restart your device and then connect to the network again. Open Settings app on your iOS device → Wi-Fi → tap on the “i” button next to the Wi-Fi network → tap on Forget this device and confirm. Now, restart your device and reconnect to the network. Hopefully, Wi-Fi begins to work well. If you don’t see any improvement, head over to this troubleshooting guide to try out several other tricks to fix the Wi-Fi issue in iOS 11.
Solution #2: Turn OFF/ON Bluetooth On your iOS Device
HomePod requires Bluetooth connection to communicate with your iOS device. Trying turning it OFF/On Bluetooth. Open Settings app on your iOS device → Bluetooth → turn off the switch. Now, wait for a couple of seconds and turn it back on. Now, try setting up the speaker. If you get through the process without any issue, wonderful! But if you still face the problem, move to the next trick.
Solution #3: Reset HomePod Manually
Reset the speaker manually. To do so, unplug the HomePod and plug it back in. Then, press and hold on top of the speaker. Keep pressing until the three beeps sound is heard. Once you have manually factory reset your speaker, you shouldn’t have any problem while setting it up. Go ahead with the process. Still No luck? If none of those mentioned above tricks have worked for you in resolving the 301003 error on the HomePod, there might be some stubborn issue preventing the speaker from setting up properly. Don’t waste any time; contact Apple Support for help. Have your say Which one of the solutions mentioned above came for your rescue? Share your feedback in the comments below. You might want to read these posts as well:
HomePod Not RespondingHow to Customize Siri on HomePodPrevent others From Using HomePod as a Speakerphone
